1. Click on "Start" in the bottom left hand corner of screen
2. Click on "Run"
3. Type in "command" and hit ok
This article will help you to change your IP address within a minute. Just follow the following step and you will be thru.
1. Click on "Start"
2. Click on "Run"
3. Type in "cmd" and hit ok
You should now be at an MSDOS prompt screen.
4. Type "ipconfig /release" and press "enter"
5. Type "exit" and leave the prompt
6. Right-click on "My Network Places" on your desktop.
7. Click on "properties"
You should now be on a screen with something titled "Local Area Connection", or something close to that, and, if you have a network hooked up, all of your other networks.
8. Right click on "Local Area Connection" and click "properties"
9. Double-click on the "Internet Protocol (TCP/IP)" from the list "General" tab
10. Click on "Use the following IP address" under the "General" tab
11. Create an IP address (Just type whatever number just to fill it up).
12. Press "Tab" and it should automatically fill in the "Subnet Mask" section with default numbers.
13. Press the "Ok" button here
14. Press the "Ok" button again
You should now be back to the "Local Area Connection" screen.
15. Right-click back on "Local Area Connection" and go to properties again.
16. Go back to the "TCP/IP" settings
17. This time, select "Obtain an IP address automatically"
18. Press "Ok"
19. Press "Ok" again
20. You should now have a new IP address
NOTE:
This only changes your dynamic IP address, not your ISP/IP address. If you plan on hacking a website with this trick be extremely careful, because if they try a little, they can trace it back
Post a Comment